- Plumbing Services
-
-
- 24/7 EMERGENCY
BURST
PIPE?
FLOODED
ROOM?We answer the phone day, night, weekends, and holidays, with same-day service across the Peninsula.
-
- About
- Service areas
- Coupons
- Financing
A tankless water heater is usually more energy efficient and lasts longer, but it often needs gas line, venting or electrical upgrades and can limit how many fixtures run at once. A traditional tank heater is simpler to install and handles several uses at once until the tank runs out. For a typical Peninsula home, the right choice depends on how much hot water you use, how many people use it at the same time, and what your existing gas and venting setup can support.
A traditional storage heater keeps a tank of water hot all day. When you open a tap, hot water leaves the tank and cold water refills it. Heat is lost through the tank walls all day, which is called standby loss.
A tankless (on-demand) heater has no storage tank. When you open a tap, flow sensors start a burner or heating element and the unit heats water as it moves through. There is no standby loss, and no tank to run out.
The U.S. Department of Energy states that for homes using 41 gallons or less of hot water a day, demand water heaters can be 24% to 34% more energy efficient than conventional storage tank heaters. For homes that use a lot of hot water, around 86 gallons a day, the gain is smaller, 8% to 14%, according to the same DOE guidance.
In practice, the more hot water your household uses, the smaller the efficiency advantage. A busy home with back-to-back showers, a dishwasher and laundry sees less benefit than a small household with modest use.
This is where tankless heaters surprise people. A tank gives you a fixed reserve. A tankless unit gives you unlimited hot water, but only up to its flow capacity. A U.S. Department of Energy Building America tankless guide explains that the maximum flow rate and temperature rise are set by the unit’s capacity, so each unit can only serve so many fixtures at once. Size matters. A unit that is too small gives lukewarm water when two showers and the dishwasher run together.
Tankless heaters also have a minimum flow before they fire. A DOE Building America guideline notes that minimum flow rates can affect common draws such as shaving or dish rinsing. Hot water can also take a few seconds longer to reach the tap after the unit senses demand, and the same guideline says delays of around 20 seconds are not uncommon in retrofits. How long you wait depends mostly on the distance from the heater to the fixture and on how the pipes are laid out.
The tankless guide states that because tankless units do not hold a tank of water, they are less subject to corrosion, and their expected life is longer: more than 20 years compared with 10 to 15 years for traditional heaters. Real life depends on water quality and maintenance. Always check the manufacturer’s stated service life for the model you are considering.
Swapping a tank for a tankless unit is not a like-for-like job in many homes. The DOE guideline warns that retrofit costs vary with venting, electrical needs and gas line upsizing.
Tank heaters need periodic flushing to clear sediment and an occasional check of the anode rod and relief valve. Tankless heaters need descaling. The tankless guide says that when the water has high mineral content, scaling of the heat exchanger is likely and the unit should be flushed with a descaling solution per the owner’s manual. If you have hard water, a water softener protects either type. Skipping maintenance on a tankless unit can cancel its lifespan advantage.
The Peninsula has a mild climate, so incoming water is not as cold as in much of the country. That makes it easier for a tankless unit to reach the set temperature at a given flow. It does not change the main questions: how many fixtures run at once, how far the heater is from the farthest bathroom, and whether your gas line and vent can support the unit. Households that use hot water in short, spaced-out bursts tend to see the best match with tankless. Households with several people showering back to back, plus laundry and dishes, often need a larger unit, or a tank with the reserve to cover the peak.
They can reduce energy use, with the biggest gain in lower-use homes, according to DOE. Whether it pays off depends on your use and on installation work such as gas line and venting upgrades.
They heat water continuously, but each unit has a maximum flow. If demand exceeds it, the temperature drops.
Rust-colored water, a leak at the base, rumbling noises and age are the common signs. See our water heater repair page for repair versus replace guidance.
Works Plumbing and Rooter, Inc. installs and services both types. See our water heater and tankless water heater pages. We are a family owned, licensed California contractor (CSLB #982663), open 24/7 with same-day service across the Peninsula. Call 650-899-3542 or contact us online and we will look at your gas line, venting and hot water use before recommending a unit.
The plumbing warning signs you should never ignore are slow or gurgling drains, sewer smells, water stains on…
READ MOREA tankless water heater is usually more energy efficient and lasts longer, but it often needs gas line,…
READ MOREYou can clear most slow or clogged drains without Drano by using a plunger, a drain snake, a…
READ MORE
A real human will answer, dispatch a stocked Works van, and get someone at your door the same day. No phone trees. No robots. No “we’ll get back to you Monday.”