A sump pump only matters on the days it has to work, which is why a failure usually shows up mid-storm. Works Plumbing provides sump pump repair in Millbrae, CA for pumps that will not start, will not stop, or run without moving water. We find the cause, repair or replace the pump, and make sure the water ends up somewhere it should.
Get a Free Estimate
Upfront pricing. Same-day service. No obligation.
"*" indicates required fields
We’ll call you back fast.
THIS MONTH’S BEST DEAL
$75
OFF
$75 OFF Any Plumbing Repair Over $500
One-time use. Combine with our 24/7 emergency service and pay only when the job is done. Mention this offer when you book.
Most sump pump failures trace back to the float switch, the check valve, power, or the discharge line.
Millbrae faces both Bay shoreline and inland storm flooding, according to the regional shoreline project.
A regional flood project does not drain the ground under an individual house.
City rules keep roof leaders and yard drains out of the sanitary sewer, so discharge routing matters.
Signs Your Sump Pump Needs Repair
Check the pit after a heavy rain. These signs mean the pump needs attention:
It hums but does not pump. Often a jammed impeller or a failed motor.
It never turns on. A stuck float, a tripped circuit, or a dead motor.
It runs constantly. A float stuck in the up position, a failed check valve, or more water than the pump can handle.
It cycles on and off quickly. A float set too tight or a check valve letting water fall back into the pit.
It makes grinding or rattling noises. Debris in the pump or worn bearings.
Water stays in the pit or spreads past it. The pump, the discharge line, or both have stopped keeping up.
Test the pump before the wet season by pouring water into the pit until the float rises. If nothing happens, call us before the next storm, not during it.
What We Check on a Millbrae Sump Pump Call
Every service call covers the same points:
Power. The outlet, the circuit, and any backup power source.
Float switch. Free movement, correct on and off levels, and no snags against the pit wall.
Pump. Intake screen, impeller, motor, and whether it moves water at the rate the pit needs.
Check valve. Whether it closes and holds.
Discharge line. Clogs, damage, and the outlet location.
The pit. Silt, gravel, and debris that can jam the pump.
Then we explain what we found and give you a written, upfront price.
Repair or Replace the Pump?
Many problems are fixable: a float switch, a check valve, a cleaned intake, or a discharge line repair. We recommend replacing the pump when:
the motor has failed or overheats,
the housing is cracked or badly corroded, or
the pump cannot keep up with the water the pit collects.
If a replacement is the better value, we tell you why and quote it before any work starts.
Where the Water Can and Cannot Go
Millbrae’s sewer rules shape how a drainage system is set up. Under Municipal Code 8.20.460, a sewer lateral inspected for a remodel permit must have no illicit connections, and the code names roof leaders and yard drains as examples. Stormwater does not belong in the sanitary sewer.
We do not route sump discharge into the sewer. We look for a discharge point that moves water away from the house without sending it onto a neighbor’s property, and we confirm requirements for your lot before changing it.
Sump Pump or Sewage Pump?
They look alike but do different jobs. A sump pump moves groundwater and stormwater. A sewage pump lifts wastewater from fixtures that sit below the sewer line.
The difference matters in Millbrae. Under Municipal Code 8.20.470 and 8.20.480, backflow protection and relief devices are required where a pump lifts sewage, where a floor is at or below the invert of the City main, and in several other cases. If your home has a sewage pump or a fixture below the main, we check those devices too. Our page on drain cleaning in Millbrae covers sewer line backups.
Is It Groundwater or a Leak?
Not every wet crawlspace is a drainage problem. A supply pipe leaking under the floor can fill a pit as well. If water appears in dry weather or the pump runs when it has not rained, we check for a plumbing leak. Our Millbrae leak detection service handles that testing.
Keeping a Sump Pump Ready Between Storms
A pump that sits idle for months needs a little attention before it is called on. Between visits:
Run a test by filling the pit with water and watching the pump start and stop.
Clear the pit of leaves, silt, and gravel that can jam the float or the intake.
Walk the discharge line to its outlet and make sure nothing has crushed or blocked it.
Check the outlet and cord for damage, and keep the cord off the pit floor.
Listen for new noises the next time it runs.
If any of these turn up a problem, schedule a repair while the weather is dry.
Permits
Millbrae’s Building Division states that a building permit application is required to “install, repair, or modify electrical, plumbing, or mechanical systems.” We confirm what your sump pump repair or replacement needs with the Building Division before work starts.
Why Choose Works Plumbing
Works Plumbing has been family owned and operated since 2009, and Millbrae is part of our Peninsula service area.
Licensed and insured (CSLB #982663)
Upfront pricing before work begins
Free estimates on pump replacement
Same-day service when the schedule allows, plus 24/7 emergency service
We at Works Plumbing test the whole system, so the next storm is not the first real test. See our full sump pump service, or every local service on our Millbrae plumbing page.
Sump Pump Repair in Millbrae, CA: FAQs
What flooding does the Millbrae shoreline project address?
The OneShoreline project for Millbrae and Burlingame names shoreline flooding from San Francisco Bay and inland flooding during major rainfall events that overwhelm local creeks and storm drain systems.
Will the shoreline project keep water out from under my Millbrae home?
It is a regional project aimed at the shoreline and public drainage, with implementation described as likely phased. Water that collects under a house still depends on private drainage, which is where a working sump pump comes in.
Can my sump pump drain into the sewer in Millbrae?
We do not connect sump discharge to the sanitary sewer. Millbrae’s lateral rules already treat roof leaders and yard drains connected to the sewer as illicit connections. We route the discharge away from the house instead.
Does my Millbrae home need a backwater valve?
City code requires backflow protection and relief devices in several cases, including where a floor is at or below the City main invert and where a pump lifts sewage. We check whether any apply to your home.
Do I need a permit to replace a sump pump in Millbrae?
The City’s Building Division says a permit application is required to install, repair, or modify plumbing systems. We confirm what your job requires before work starts.
Get Your Sump Pump Ready for the Next Storm
Do not wait for a full pit to find out the pump is not working. Book sump pump repair with Works Plumbing and we will test, repair, and explain everything before the rain returns.
Why Millbrae homeowners call Works
Stocked trucks already in the area, so we arrive fast
Upfront, flat-rate pricing approved before any work
We’re highly experienced with: Leak detection Drain cleaning Drain repair Rooter services Water heaters Sprinkler systems Tankless water heaters Toilet repair & installation Faucet repair & installation Shower repair & installation Trenchless sewer repairs Camera inspections Garbage disposals Gas lines Gas valves Burst pipes Pipe repair Sump pumps Sewer repairs Hydro jetting Pipelining Plumbing repairs
What’s included
Drain cleaning & rooter service
Water heater repair & install
Leak detection
Gas line service
Emergency plumbing
Repiping & trenchless
How the job goes
We diagnose the issue and show you a flat price upfront.
You approve it, then our tech gets to work from a fully-stocked truck.
We test the fix twice and leave your space cleaner than we found it.
Our crew on a recent job across the Peninsula.
Why Choose Works Plumbing
Sump Pump Replacement Experts The team from Works Plumbing wants to take the stress out of dealing with a faulty sump pump in Millbrae. Our company is proud to offer 24/7 emergency availability for any situations that need to get addressed in a timely manner. We offer flexible financing options on approved credit to make it easier to pay for a new sump pump. Our locally owned and operated company was founded in 2009, and we’re committed to exceeding the expectations of each of our customers. We have a shop located off of Palmetto Avenue in Millbrae, and our plumbers are ready to respond to all service requests in a prompt and professional manner. We’ll arrive at our appointments punctually and have all of the tools needed for the job. You can trust us to give every job our full attention. To learn more about how we can help you get a new sump pump for your Millbrae home, give the team from Works Plumbing a call today. Plumbing Repair Toilet Repair Shower Repair Hydro Jetting Camera Inspection Leak Detection Gas Line Repair Trenchless Pipe Repair Water Line Repair Sump Pumps Garbage Disposal Drain Cleaning Faucet Repair Hot Water Heater Repair Tankless Water Heaters
Pro tip
Snap a photo of the problem before you call, it helps us bring the right parts on the first visit.
See how we handle it:
Ready to get it fixed?
Upfront pricing, licensed techs, and a real human on the phone 24/7 across the Peninsula.
Millbrae’s Flood Risk and the Pump Under Your House
Millbrae’s flooding picture is being studied at a regional scale. The OneShoreline Millbrae and Burlingame Shoreline Resilience Project names two flood hazards for the area: “Shoreline flooding from San Francisco Bay” and “Inland flooding during major rainfall events that overwhelm local creeks and storm drain systems.” Project maps show the Highline and El Portal canals. The project page targeted a draft environmental impact report for late spring 2026 and describes implementation as likely phased.
That project is aimed at the shoreline and the public drainage network. It is not designed to manage the water that collects under one home. When heavy rain overwhelms creeks and storm drains, water has fewer places to go, and low spots around a foundation are where it ends up. A sump pump is the private piece of that system:
The pit collects water that reaches the low point of a crawlspace or lower level.
The float switch starts the pump when the water rises.
The pump lifts the water out through the discharge line.
The check valve keeps that water from falling back into the pit.
A pump that fails during an inland storm event fails at exactly the wrong moment. So our repair visits test the whole chain, not just the motor. We also look at where the discharge line ends. Water pumped out next to the foundation can find its way right back in.
We’ve earned our reputation one happy homeowner at a time.
“Thank you again for another job well done, and thank you for responding right away. I will continue to recommend Works Plumbing because they respond right away and get the job done efficiently.”
DK
David K.
San Mateo Google Review
Google reviews
Yelp reviews
Pay Your Way
BIG REPAIR? SMALL PAYMENTS.
Plumbing emergencies don’t wait for payday. Spread your cost over 12, 24, or 60 months with affordable financing options through trusted partners.
A real human will answer, dispatch a stocked Works van, and get someone at your door the same day. No phone trees. No robots. No “we’ll get back to you Monday.”