Shower repair in Daly City, CA fixes the problems that make a daily shower annoying or wasteful: a constant drip, a handle that will not shut off, water that swings between hot and cold, or spray that has faded to a trickle. Works Plumbing finds the failed part, repairs it, and checks whether something upstream is wearing it out.
Get a Free Estimate
Upfront pricing. Same-day service. No obligation.
"*" indicates required fields
We’ll call you back fast.
THIS MONTH’S BEST DEAL
$75
OFF
$75 OFF Any Plumbing Repair Over $500
One-time use. Combine with our 24/7 emergency service and pay only when the job is done. Mention this offer when you book.
Most shower repairs are finished in one visit. Request shower repair and tell us what you are seeing.
The Problem, the Cause, the Fix
Start with what the shower is doing. Each symptom narrows the search.
What you notice
Common cause
Usual repair
Drip from the head or spout after shutoff
Worn cartridge or seals
Replace the cartridge or seals
Handle hard to turn or loose
Worn cartridge or stem
Replace the cartridge and trim parts
Water too hot or too cold, or swings
Failed balancing part in the valve
Repair or replace the valve internals
Weak spray from the head
Clogged head or flow restrictor, or a valve issue
Clean or replace the head, check the valve
Water stays in the tub spout during a shower
Worn diverter
Replace the diverter or spout
Water in the ceiling or wall below
Leak at the valve, arm, or drain
Find the source, then repair
When the same part fails again soon after a repair, we look past the shower for the reason.
Dripping Showers and Worn Cartridges
A drip that will not stop is almost always inside the valve. Most single-handle showers use a cartridge that controls both flow and temperature. When its seals wear, water passes even with the handle off.
We shut off the water, pull the cartridge, and match it to the valve brand. Then we:
Replace the cartridge with the correct part
Check the valve body for scale or damage
Replace worn trim seals
Test for drips at the head and spout
A cartridge that fails within a year or two is a warning sign. That is where water pressure comes in.
Our Shower Repair Process
Listen and look. We confirm the symptom and check the trim, head, and spout.
Test pressure. We read static pressure at the house.
Shut off and open the valve. We use the shower’s own stops when it has them, or the house main.
Repair. We replace the cartridge, seals, diverter, or valve internals.
Test. We run the shower hot and cold, check for drips, and look for leaks.
Report. You hear what we found, what we fixed, and anything that needs attention.
Leaks Behind the Wall or Below the Floor
A stain on the ceiling under a bathroom is not always the shower valve. The water can come from:
A loose shower arm connection behind the head
A cracked or failed valve body
A drain connection that leaks only when the shower runs
Failed grout or caulk letting water behind the tile
We narrow the source before opening anything. If the wall must be opened, we tell you how large the opening will be and where, and we price the repair first. A leak that stops when the shower is off often points to the drain or the surround, not the supply.
Weak Spray and Temperature Problems
A weak shower is often a clogged head or a flow restrictor, which we can clean or replace. If the whole house has weak pressure, the cause may be upstream, such as a supply line leak. Our page on water line repair in Daly City covers that case.
Temperature swings are usually a worn pressure-balancing part inside the valve. When someone flushes a toilet and the shower turns hot, that part is not keeping up. We repair or replace it so the temperature holds.
When a Shower Problem Cannot Wait
Most shower problems are a nuisance, not an emergency. A few need attention the same day:
Water dripping through a ceiling or light fixture below the bathroom
A valve that will not shut off at all
Scalding water with no way to adjust it
Water seeping out from under the tub or shower base onto the floor
If water is coming through a ceiling, shut the water off at the main and keep the area clear of electrical fixtures. We offer 24/7 emergency service for active leaks. A slow drip or a weak spray can wait for a regular appointment, but fixing it soon keeps water off your bill and out of the wall.
When the Valve Itself Needs Replacing
Most valves are worth repairing. Replacing the valve body makes sense when:
Parts for the brand are no longer made
The valve body is cracked or badly scaled
The valve cannot hold a steady temperature after repair
A valve replacement usually means opening the wall behind the shower. We discuss access, tile, and price before you decide.
Why Daly City Homeowners Choose Works Plumbing
We at Works Plumbing have been family owned and operated since 2009. On a shower repair, you get:
A licensed and insured (CSLB #982663) plumber
A pressure check, not just a part swap
A price you approve first, with free estimates
Same-day service when possible and 24/7 help for active leaks
Shower Repair in Daly City, CA: Frequently Asked Questions
Why does my new shower cartridge keep failing in Daly City?
High static pressure is a common reason. Daly City’s water heater guidance calls for a pressure regulator to bring static pressure to 80 psi or less where it is excessive. We test your pressure so the new part does not wear out early.
Is water pressure the same across Daly City?
No. The city’s water system runs through 23 pressure zones, so two homes in different parts of the city can see different static pressure. We measure it at your house.
Do I need a pressure regulator?
Only if your static pressure is excessive or your current regulator is failing. We read the pressure first. If a regulator is needed, the city’s guidance also covers the expansion tank that may go with it.
Does Daly City water cause scale in my showerhead?
The city publishes hardness for its SFPUC supply, but not for the blended SFPUC and well water at your tap. We look at your actual showerhead and valve. If we find scale, we clean or replace the parts.
Can you fix my shower without removing tile?
Most repairs, including cartridge, seal, and diverter work, are done from the front of the valve without touching tile. Opening the wall is only needed for a valve body replacement or a hidden leak.
Will a shower repair change my water heater?
No. But if the pressure test shows a problem, the fix may involve the regulator or expansion tank that the city’s water heater guidance describes. We explain that before any work.
Installation and Repair your Indoor/Outdoor Shower
You have to do it right for the first time in the first installation of your new shower or shower part. If a shower is not correctly mounted, the problems it creates may be more than just uncomfortable. A wrongly installed shower can leak or flood your house, causing severe water damage to neighboring areas. Furthermore, if a shower is not appropriately installed for the first time, it may be expensive to repair in the future. Trusted plumbers must install a shower to be reliable from day One to year 10. Works Plumbing has a plumbing team to equip the perfect shower to suit your needs. We Install the Following Shower Components: Stand-alone showers Whirlpool tubs Hot tubs Stand bathtub Walk-in tubs
What’s included
Drain cleaning & rooter service
Water heater repair & install
Leak detection
Gas line service
Emergency plumbing
Repiping & trenchless
How the job goes
We diagnose the issue and show you a flat price upfront.
You approve it, then our tech gets to work from a fully-stocked truck.
We test the fix twice and leave your space cleaner than we found it.
Our crew on a recent job across the Peninsula.
Why homeowners choose Works
Every job comes with upfront pricing, licensed and background-checked technicians, and a 100% satisfaction guarantee . No surprises, no pressure, ever.
Pro tip
Snap a photo of the problem before you call, it helps us bring the right parts on the first visit.
See how we handle it:
Prefer to listen? Catch this topic on our homeowner podcast:
▶
The Works Plumbing Podcast Homeowner Tips
Ready to get it fixed?
Upfront pricing, licensed techs, and a real human on the phone 24/7 across the Peninsula.
The City of Daly City addresses house water pressure in its own permit guidance. On its water heater requirements page, the city states that a pressure regulator with a strainer is required to reduce static pressure to 80 psi or less where pressure is excessive. The same page calls for an expansion tank when supply pressure exceeds the relief valve setting, or when a device such as a pressure regulator without bypass blocks relief to the supply.
Those rules sit on a water heater page, but the pressure reaches every fixture in the house. Your shower valve sees it too.
Here is how the wear happens. Static pressure is the force in your pipes when nothing is running. A cartridge and its seals hold back that force around the clock. Higher pressure pushes harder against the seals, so they wear faster and start to weep. A faulty or missing regulator can also let pressure spike, which shows up as banging pipes or a shower that surges.
Pressure is not the same everywhere in Daly City, because the city water system runs through 23 pressure zones.
That is why we test before we only replace parts. On a Daly City shower call, we put a gauge on an outside hose bib or laundry valve and read the static pressure. If it is above 80 psi, or a regulator is failing, we tell you, so the new cartridge does not wear out early.
We’ve earned our reputation one happy homeowner at a time.
“Thank you again for another job well done, and thank you for responding right away. I will continue to recommend Works Plumbing because they respond right away and get the job done efficiently.”
DK
David K.
San Mateo Google Review
Google reviews
Yelp reviews
Pay Your Way
BIG REPAIR? SMALL PAYMENTS.
Plumbing emergencies don’t wait for payday. Spread your cost over 12, 24, or 60 months with affordable financing options through trusted partners.
A real human will answer, dispatch a stocked Works van, and get someone at your door the same day. No phone trees. No robots. No “we’ll get back to you Monday.”